公司新聞

裝載機租賃的七點操作步驟

來源：http://m.runbangpharm.com/ 日期：2022-10-05

裝載機主要用于鏟裝土壤、砂石、石灰、煤炭等散狀物料,也可對礦石、硬土等作輕度鏟挖作業，等等，下面濟南裝載機租賃廠家來講講裝載機租賃的七點操作步驟。

The loader is mainly used to shovel soil, sand, lime, coal and other bulk materials, and can also shovel ore, hard soil, etc. slightly. Next, Jinan Loader Rental Factory will talk about the seven operating steps of loader leasing.

1、將車倒到佳裝載位置

1. Reverse the vehicle to a good loading position

裝載機裝車之前,注意觀察將翻斗車倒到工作區的佳位置,這樣既能節省時間,也能提高效率，

Before loading the loader, pay attention to observe that the dumper is placed at a good position in the working area, which can save time and improve efficiency,

2、裝車前先想好裝車順序

2. Think about the loading sequence before loading

裝載機裝載前應先想好裝載順序,盡量都靠近車廂前面,因為這樣裝起來快封頂?shù)臅r候不會說前面少了半鏟，

Before loading, the loader should first think about the loading sequence and try to be close to the front of the carriage, because when it is installed and quickly capped, it will not say that half of the shovel is missing,

3、把組合動作配合好

3. Match the combined movements well

(1)鏟入:行走(前沖)、放大臂、放平斗同時做,即走到料堆前時,你的鏟斗也應正好放到位,可以借著沖勁鏟入，

(1) Shovel in: walk (forward thrust), enlarge the arm, and level the bucket at the same time, that is, when you reach the pile, your bucket should also be in place, which can be shoveled in with momentum,

(2)翻斗、提臂和倒車同時做,邊倒車邊緩慢提大臂、擺正鏟斗,倒正換前進檔后,繼續邊走邊提大臂，

(2) The tipping bucket, arm lifting and reversing shall be carried out at the same time. While reversing, slowly lift the boom and straighten the bucket. After reversing and changing the forward gear, continue to lift the boom while walking,

(3)卸料:走到離車箱不遠時就要開始翻斗卸料,不用擔心物料倒出來,因為動作如果足夠快的話,物料會由于慣性的作用遲滯一下才會開始滑落,不會立馬下來的，

(3) Unloading: When you are not far away from the car body, you should start dumping with the tipping bucket. Don't worry about the materials pouring out, because if you move fast enough, the materials will start to slide due to the inertia effect, and won't come down immediately,

(4)待鏟斗達到車廂邊緣內后,在繼續翻斗的同時,還要同時降一些大臂,到合適的位置后,使鏟斗正好翻到位,也停止降大臂,同時再點一下剎車,物料會因慣性的沖勁迅速滑落的,總之不要停頓一秒的時間，

(4) When the bucket reaches the edge of the carriage, while continuing to turn the bucket, lower some booms at the same time. When the bucket reaches the proper position, make the bucket just turn to the right place, and stop lowering the boom. At the same time, press the brake again. The materials will slide rapidly due to the momentum of inertia. In short, do not stop for a second,
濟南裝載機租賃

4、掌握好裝車時間差

4. Master the loading time difference

鏟料時,右手要勤快,當車子阻力大了不動時,要多操縱動臂搖臂,不要阻力一大就猛加油門,那樣既浪費燃油又傷車,還不能提高工作效率，

When shoveling materials, the right hand should be diligent. When the car's resistance is too high to move, the rocker arm of the boom should be operated more. Don't suddenly increase the accelerator when the resistance is too high. That will not only waste fuel and hurt the car, but also can't improve work efficiency,

5、每鏟均勻往車廂里倒

5. Evenly pour each shovel into the carriage

不管車子多大,車廂總是方的,四周是有圍擋的,而沙石是散的,你只往中間倒,肯定倒成一座小山",那不就中間冒尖,四面不滿嘛,所以你要控制每鏟的位置,相對均勻的往車廂里倒，

No matter how big the car is, the carriage is always square, there are fences around it, and the sand and stone are scattered. If you only fall in the middle, you will certainly fall into a hill,

6、快滿時將高出部分推平

6. Push the higher part flat when it is almost full

快滿了的時候可將物料慢慢的推過去,盡量使物料推到較少的一邊,因為實際裝載時,裝載機升不到那么高，如果還差一鏟就裝后面,因為你一次性前面裝的太滿了封頂?shù)臅r候會很不方便，

When it is almost full, you can push the materials slowly to the side with less materials as far as possible, because the loader can not rise so high during actual loading. If you need a shovel, you can load it at the back, because it will be inconvenient to pack the front too full at one time,

7、封頂時前后各裝一鏟

7. When capping, install a shovel at the front and back respectively

倒車的時候可以用眼睛瞄一下車廂地下是不是掉料了，如果發現裝的可以封頂時,可以采取前后分別裝載一鏟,進行封頂,封頂時不要裝得太高以免產生崩塌，

When backing up, you can use your eyes to see if there is material falling under the car. If it is found that the top can be sealed, you can load a shovel in the front and back separately to seal the top. Do not install the top too high to avoid collapse,

此外運行停機后,裝載機應選擇堅硬的地面停放,若在坡道上停放時,輪胎前后應用三角木楔住，相關細節事項要注意，關注我們http://m.runbangpharm.com了解更多！

In addition, after the operation and shutdown, the loader should be parked on a hard ground. If the loader is parked on a ramp, the front and back of the tires should be wedged with triangular wood. Pay attention to relevant details http://m.runbangpharm.com Learn more!

上一條：挖掘機起動性能良好的條件有哪些？

下一條：水泥穩定碎石的原材料與施工機械設備分析